M Series (dc) | Bel Power Solutions

Input: Wide input (4:1)
Outputs: 5 to 48V
Power: 50 Watt
Tamb: -40 to +71°C
Dims: 168 x 111 x 40mm (3U x 8TE)
UL / CE EN60950 Approved
5 year warranty

Have a question? Call us now

+44 (0)1722 413 060

Application

The M Series of DC-DC and AC-DC converters represents abroad and flexible range of power supplies for use in advanced industrial electronic systems. Features include high efficiency,reliability, low output voltage noise and excellent dynamic response to load/line changes due to individual regulation of each output.

The converter inputs are protected against surges and transients occuring at the source lines. An input over- and undervoltage lockout circuit disables the outputs, if the input voltage is outside the specified range. An inrush current limitation prevents circuit breakers and fuses from tripping at switch-on.

All outputs are open- and short-circuit proof, and are protected against overvoltages by means of built-in suppressor diodes.The outputs can be inhibited by a logic signal applied to the connector (pin 2). If the inhibit function is not used, pin 2 should be connected to pin 23 to enable the outputs.LED indicators display the status of the converter and allow
visual monitoring of the system at any time.

Full input to output, input to case, output to case, and output to output isolation is provided. The converters are designed and built according to the international safety standard IEC/EN 60950-1 and UL/CSA 60950-1, and they have been approved by the safety agencies TUV and UL.

The case design allows operation at nominal load up to 71 °C in a free-air ambient temperature. If forced cooling is provided,the ambient temperature may exceed 71 °C but the case temperature should remain below 95 °C under all conditions.

A temperature sensor generates an inhibit signal, which disables the outputs, when the case temperature TC exceeds the limit.The outputs automatically recover, when the temperature drops below the limit.

Various options are available to adapt the converters to individual applications.

The converters may either be plugged into a 19″ rack system according to IEC 60927-3 or be mounted onto a chassis or a plate.

Feature List

Extremly wide operating input voltage ranges from 8 to 385 VDC and 85 to 264 VAC, 47 to 440 Hz
RoHS lead-solder exemption compliant
Class I equipment
Input over- and undervoltage lockout
1, 2, or 3 individually isolated and controlled outputs up to 64 V
Outputs: SELV, no load, overload, short-circuit proof, rectangular current limiting characteristic
Adjustable output voltages with remote on/off
Immunity according to IEC/EN 61000-4-2, -3, -4, -5, -6
Emissions according to EN 55011/55022
PCBs protected by lacquer
Very high reliability
Battery charger models available
Safety according to IEC/EN 60950-1 and UL/CSA 60950-1
5 year warranty on -G versions